Friday, May 16, 2008
Friday, May 16, 2008 |
 |
 |
 |
 |
 |
 |
 |
|
|
 |
|
Total number of controlled axis |
8 |
|
Total number of spindle axis |
1 |
|
Number of following axis |
2 |
|
Feed range |
0.51 to 64,000 mm/min (0.02 to 2500 ipm) |
|
Maximum encoder counts per second |
4,000,000 |
|
Maximum acceleration |
10g |
|
programmable limits for maximum feed |
Per axis: positioning, jog, dry run feed |
|
programmable limits for maximum acceleration |
Per axis: positioning and interpolation |
|
Jog |
Common: positioning and interpolation |
|
Feed
rate override |
Up to 31 programmable steps, 0.0 to 199.9% |
|
Maximum table travel per command |
Approximately 1 Kilometer |
|
Maximum rotary travel per command |
10,000 revolutions with optional electronic unwind |
|
Control accuracy |
15 Digit floating point |
|
Maximum value of any dimension |
1,000,000,000,000.0000 |
|
Range of dwell |
.01 second to 300,000 years |
|
Maximum program size |
40 GiG Hard Drive |
|
Tool data storage |
254 tools per table (mixed inch/metric data) |
|
Lead screw compensation |
1 Table per axis, variable size (random points) |
|
Mapping (3D compensation) |
1 table of unlimited size. (Full geometry correction) |
|
Compensation table size |
65,000 random location points |
|
Digital I/O's |
up to 144 inputs, 144 outputs |
|
Analog and odd I/O's |
up to 18 addresses (analog I/O's are multiplexed) |
|
Look-ahead distance |
80 buffers (approximately 15 inches) |
|
Parameters |
100 for programs, 100 for canned-cycles (15 digit) |
|
Parameters in user defined arrays |
8200 |
|
PLC registers |
400 (16 bit) |
|
Compilers |
CNC
Programs: virtual code |
| Safety |
 |
|
Specialty Features Made Possible |
|
| On
the fly (Dynamic) Z axis offset The one great feature about a knee mill is the ability to crank the table up or down as desired even while cutting the part. This is now possible in the Numatix controller and not just in the Z axis.
Each axis can be cranked into a new relative position even while cutting your part. |
|
| 2
axis programming from CAD is automatically wrapped onto a 4th axis cylinder
Developed especially for the roll die industry, this feature saves many hours of CAD time. |
|
| Custom
Menus Your control comes complete with all the tools available to customize your screen. Many customers find it valuable to generate custom menus to prompt the operator through the part setup or to complete complex formulas based on the operator's input. |
 |
